Author: Site Editor Publish Time: 2024-04-28 Origin: Site
FRL in the pneumatic industry is the abbreviation of the air source triplex, F = air filter; R = pressure reducing valve: L = oil mist.
FRL means a pneumatic triplex consisting of an air filter, a pressure reducing valve and an oil atomiser. In the pneumatic circuit, it is a pneumatic component with the three functions of FRL.
Air source processing device is the compressed air in the water and solid particles separated out to achieve the role of purification, and then the air compressor or gas station to send over the compressed air adjusted to the pressure required by the equipment; Finally, in the clean instrument wind to add atomised lubricant, so that those who are not easy to add lubricant after the instrumentation of the equipment to play a lubricating effect to ensure the quality and stability of the compressed air to ensure that the system operates normally, thus ensuring the normal operation. Play the role of extending the service life of the equipment. Air source treatment device consists of air inlet, filter, dryer, pressure reducing valve and lubricator.
Three pieces: from left to right are: air filters, pressure reducing valve, oil mist
Although the air processor is a relatively durable components, but its service life has a certain cycle. In general, the service life of the air processor for 2 to 3 years or so, the specific time will also be affected by its operating environment, frequency of use, quality and other factors.
Therefore, in the normal use of gas processor process, it is recommended that at least one inspection per year, including checking the working status of each component, the degree of contamination of the filter, the accuracy of the pressure reducer and lubricator, etc., in order to find and deal with the problem in a timely manner, and monthly cleaning or replacement of the filter filter, take out the filter, and blow the filter from the inside out, can be reused. At the same time, in the inspection process, you can also view the use of the processor, according to the actual situation to determine whether the need to replace the wearing parts of it.
Correct maintenance and use of the gas processor, not only to extend its service life, but also to ensure its normal operation. The following are some common ways to maintain the processor:
1. Regular inspection: Do not ignore the importance of regular inspection of the gas processor, you can follow the official recommended cycle of inspection and maintenance.
2. Clean filters: For filter cleaning and replacement, it should be done according to the actual situation.
3. Maintenance pressure: should follow the principle of pressure moderation, to ensure that the pressure in the appropriate range, to avoid excessive pressure on the processor, which may lead to shorten the life of the processor.
4. Maintain dryness: The dryer of the processor should be drained in time to keep it dry. If replacement parts are needed, the original parts should be purchased in time to avoid incompatibility problems.
Maintenance of the gas processor is to ensure its normal operation and extend the service life of the key, in the process of using the processor, you need to master the appropriate maintenance methods, timely inspection and deal with the problem, so as to protect the normal operation of the system.
