CY1S Series Rodless Magnetic Cylinder-Slide Bearing Type

Hard Oxidation Treatment Process is Adopted To lmproveIts Wear Resistance And Corrosion Resistance

Quantity:
Availability:





Inquire Add to Basket

Model:
CY1S

Product Description

Bore size(mm		6	10	15	20	25	32	40
Fluid		Air
Proof pressure		1.05MPa
Max.operating pressure		0.7MPa
Min.operating pressure		0.18MPa
Ambient and fluid temperature		-10 to 60℃ (No freezing)
Piston speed*		50 to 500 mm/s
Cushion		Rubber bumper/Shock absorber
Lubrication		Not required (Non-lube)
Stroke length tolerance(mm)		0 to 250 st:+1.0,251 to 1000 st:+1.4,1001 st an d up:+1.8
Holding force(N	Type H	19.6	53.9	137	231	363	588	922
	Type L	一		81.4	154	221	358	569
Standard equipmen		Auto switch mounting rai

∗ In the case of setting an auto switch at the intermediate position, the maximum piston speed is subject to restrict for detection upon the response time of a load (Relays, Sequence controller, etc.).

Product Specification

Bore size(mm)	6	10	15	20	25	32	40
Workingfluid	Compressedair
Proof pressure	1.05MPa
Working pressure	0.18~0.7MPa
Working temperature	~10~60 degree
Piston speed	50~500mm/s
Cushion	Rubber bumper at both end
Lubrication	no need lubrication
Mounting method	Direct mount type

详情3

详情4

Installation, use, and post maintenance

1. When there is a change in load during work, cylinders with sufficient output force should be selected

2. Under high temperature or corrosive conditions, corresponding cylinders with high temperature or corrosion resistance should be selected

3. In places with high humidity, high dust, water stains, oil stains, and welding slag, it is necessary to protect the cylinder

4. Before connecting the cylinder to the pipeline, it is necessary to clean the dirt inside the pipeline to prevent debris from entering

5. In low-temperature environments, antifreeze measures should be taken to prevent the water seal in the system from thawing

6. The cylinder should be filtered with a filter element of at least 40M before use

7. Avoid lateral loads, otherwise the piston rod is prone to deformation and thread damage. Load when one-way non returnable

8. If the cylinder is removed and not used for a long time, attention should be paid to rust prevention, and dust blocking caps should be added to the intake and exhaust ports