| Quantity: | |
|---|---|
ALC/JGL
Product Name | ALC JGL Pneumatic Lever Twist Clamp Cylinder |
Body material | Aluminum |
Working Pressure | 0.1-1.0Mpa |
Temperature | -10 to 60 ℃ |
Cylinder Bore(mm) | Stroke(mm) | Chucking Powe（kg/CM⊃2;） | Port size | Opening Angle |
25 | 20 | 15 | M5*0.8 | 65° |
32 | 23 | 25 | PT1/8 | 67° |
40 | 25 | 44 | PT1/8 | 72° |
50 | 30 | 71 | PT1/4 | 78° |
63 | 35 | 136 | PT1/4 | 66° |
Installation, use, and post maintenance
1. When there is a change in load during work, cylinders with sufficient output force should be selected
2. Under high temperature or corrosive conditions, corresponding cylinders with high temperature or corrosion resistance should be selected
3. In places with high humidity, high dust, water stains, oil stains, and welding slag, it is necessary to protect the cylinder
4. Before connecting the cylinder to the pipeline, it is necessary to clean the dirt inside the pipeline to prevent debris from entering
5. In low-temperature environments, antifreeze measures should be taken to prevent the water seal in the system from thawing
6. The cylinder should be filtered with a filter element of at least 40M before use
7. Avoid lateral loads, otherwise the piston rod is prone to deformation and thread damage. Load when one-way non returnable
8. If the cylinder is removed and not used for a long time, attention should be paid to rust prevention, and dust blocking caps should be added to the intake and exhaust ports
